Select your COM port under connect using. Enter a name for your connection and click OK.
The RS232 Loopback Test allows users to transfer data from the Transmission Conclusions to the Reception Conclusions. Dear Friends, Here is second part of this tutorial series that is How to use hyper-terminal and serial communication with FPGA device using RS232 proto. Use the Diagnostics tab ( Figure B) to query the modem and view the modem log when troubleshooting communications problems. You are prompted to select an icon to represent the connection you are about to define. To perform an RS232 loopback test: the first step is to assure that the TXD pins and RXD pins are connected. Click the Modems tab, select the modem, and click Properties.
If you are asked if you would like to install a modem, select No.Select Start>Programs>Accessories>Hyperterminal.Verifying a Serial Port Hyperterminal Test The following test writes to the serial port and reads from the same port (make sure you have a loopback configuration set up as described in the page): The initial set up of HyperTerminal is now complete. Serial USB Terminal is a line-oriented terminal / console app for microcontrollers, arduinos and other devices with a serial / UART interface connected. Leave ‘Stop bits:’ at 1 and ‘Flow control:’ on Hardware. Software To Test Serial Port How To Configure Hyperterminal To set up a serial terminal connection in HyperTerminal, First enter a name for your connection, click OK.
Either set ‘Data bits:’ to 8 and ‘Parity:’ to None or set ‘Data bits:’ to 7 and ‘Parity:’ to Even. ‘Data bits:’ and ‘Parity:’ will be set one of two ways.